Biolight Meditech P1 - Transferring Patient Data

P1 Patient Monitor User’s Manual
4-3

To edit patient information, follow this procedure:
1. Enter the 【Patient Management】 menu. For more information,please refer
to 4.3.1 Patient Management menu.
2. Select patient type according to the actual situation: 【Adult】, 【Pediatric】,
【Neonate】.
3. Edit patient information as required.
If your monitor is connected with the barcode scanner, you can enter the medical
record number by scanning the barcode.
NOTE
：
 The setting of patient type determines the algorithm used by the monitor to
process and calculate certain measurements, as well as the safety limit and
alarm limit range applicable to certain measurements.
 The monitor reloads the configuration when the patient type is changed.
4.3.3. Setting the Display Item
You can set whether to display and edit patient room number, middle name, race, age,
and so on in the 【Patient Management】 menu by following these steps:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input passwordEnter.
2. Select【Patient Management】submenu【Field】submenu.
3. Select which the patient information needs to be displayed and edited in the
【Patient Management】 menu.
4. Select customizes the patient information section, if necessary, and enters the
name of the section.
4.4. Transferring Patient Data
The process of transferring data between two monitors is called data transfer. You do
not need to re-enter patient information or change settings after transferring patient data.
The transmission of patient data is also convenient for you to understand the patient’s