Biolight Meditech P1 - Loading Current Configuration; New Patient Usage Configuration

P1 Patient Monitor User’s Manual
5-3

5.5.2. Importing a configuration
You can import the user configuration to the monitor through a USB drive by
following these steps
1. Connect the USB drive to the monitor’s USB port.
2. Select【Main Menu】quick keyfrom【Configuration】column to select
【Import User Config】input maintenance passwordEnter.
3. Select configuration that needs to be imported.
4. Select【OK】.
5.6. Loading current configuration
You may make changes to some settings during operation. However, these changes
or the pre-selected configuration may not be appropriate for the newly admitted patient.
Therefore, the monitor allows you to load a desired configuration so as to ensure that all
the settings are appropriate for your patient.
To load a configuration
by following these steps:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
【Load Current Config】.
2. Select
configuration that needs to be loaded.
3. Select【OK】.
5.7. New Patient Usage Configuration
When receiving patients, you can select loading the nearest configuration or the
specified configuration. You can set the default configuration by following these steps:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
【New Patient Config】input maintenance passwordEnter.
2. Select【Default】or【Current】.
 【Default】: The monitor loads the default configuration specified by
the user when it receives the patient, please refer to 5.2 Selecting
Default Configuration.
 【Current】: The monitor loads the nearest configuration when it
receives the patient.