Biolight Meditech P1 - Oxycrg Screen

P1 Patient Monitor User’s Manual
6-3

 Select【Main Menu】quick keyfrom【Display】column to select【Screen
Select】Select
the screen you need to enter.
6.3. OxyCRG screen
The OxyCRG screen graphically displays high-resolution trend curves and
compressed waveforms of HR, SpO
2
, and RR.
6.3.1. Entering OxyCRG screen
You can enter the OxyCRG screen by any of the following methods:
 Select【Screen Setup】quick keySelect【Screen Select】submenuSelect
【OxyCRG View】.
 Select【Main Menu】quick keyfrom【Display】column to select【Screen
Select】Select【OxyCRG View】.
The OxyCRG screen shows two trend curves and a compression waveform.
6.3.2. Select Display Parameters and Scales
Follow the steps below to set the parameters of the OxyCRG screen:
1. Enter
OxyCRG screen.
2. Select【Setup】.
3. Set【Trend 1】, 【Trend 2】, 【Compressed Wave】separately.
4. Select 【Scale】 submenu, set the scales of each parameter. If you want to use
the default scaleplate of the system, select the 【Default Scale】on the
OxyCRG screen.
6.3.3. Setting the Trend Time
Follow the steps below to set the Trend Time:
1. Enter OxyCRG screen.
2. Select【Zoom】.
6.3.4. Entering OxyCRG Review Screen
You can review the 48-hour trend curve and compression waveform on theOxyCRG