P1 Patient Monitor User’s Manual
3-3
3.2. Getting Started
3.2.1. Connecting the Power
Connecting the AC power
The monitor can be powered by power supply when it is connected to the AC adapter
or Docking Station. Before connecting the equipment to the AC mains, check the voltage
and frequency ratings of the AC power are the same as those indicated on the AC adapter
or Docking Station.
WARNING：
Always use the accompanying power cord delivered with the monitor.
Always use the power adapter specified by manufacturer.
Use the battery if the integrity of the protective earth conductor or the
protective earthing system in the installation is in doubt.
Using battery
The monitor can be powered by a rechargeable lithium battery. After the battery is
installed, if the external power supply is suddenly interrupted, the monitor can
automatically use the lithium battery to supply the power. For the use of the battery,
please refer to Chapter 18 Battery.
3.2.2. Starting the Monitor
After installing the monitor, you can monitor the patient.
1. Before powering on the monitor, please check whether there has mechanical
damaged, external cables and accessories connect correctly.
2. Connect the monitor to the AC adapter or Docking Station. If using battery
power, make sure there is enough power in the battery.
3. When
pressing the power switch, the alarm light will display red, yellow and
cyan in turn. After the alarm light is turned off, the screen will display the
startup interface. After the system emits a beep, the startup screen disappears
and enters the main monitoring interface.
To Next Page
Loading...