Biolight Meditech P1 - Monitor Boot Usage Configuration; Setting Password Valid Time

P1 Patient Monitor User’s Manual
5-4

5.8. Monitor Boot Usage Configuration
You can select whether the monitor loads the nearest configuration or the specified
configuration. You can set the default configuration by following these steps:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
【Boot Config】input maintenance passwordEnter.
2. Select【Default】or【Current】.
 【Default】: The monitor loads the default configuration specified by
the user
 the user when it starts. Please refer to 5.2 Selecting Default
Configuration.
 【Current】: The monitor loads the nearest configuration when it starts.
5.9. Setting password valid time
If you access the configuration management menu and use the password to access
alarm-related settings, you can set a valid time for the password, beyond which you will
need to re-enter the password.
Please follow the steps below:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select【Authorization】submenu.
3. Set【Retention Time】.