P1 Patient Monitor User’s Manual
19-3
Name Type Manufacturer
Isopropyl alcohol, 70% Liquid -
Sodium hypochlorite, 0.5% Liquid -
Alcohol, 70% Liquid -
Hydrogen peroxide, 3% Liquid -
19.4. Cleaning and Sterilizing of Accessories
For cleaning, disinfection and sterilization methods of reusable accessories such as
sensors, cables and lead wires, please refer to the instructions of relevant accessories.
Please refer to this section if the attachment does not include instructions.
19.4.1. Safety information
CAUTION:
Do not immerse accessories in water or disinfectant.
Do not wet the pins of the accessories.
Frequent disinfection of accessories can cause damage to them. It is suggested
that according to hospital regulations, accessories should be disinfected only
when necessary.
When cleaning and disinfecting NIBP airpipe, liquid should be prevented from
entering the airpipe.
Use only the detergents and disinfectants specified in this manual.
19.4.2. Cleaning of the accessories
Use a soft cloth that cannot bear balls, wet and clean the accessories with an
appropriate amount of water or alcohol-based detergent (such as 70% ethanol). After
cleaning, place the accessories in a cool and ventilated environment to dry.
19.4.3. Disinfection of the accessories
You can disinfect the accessories of the monitor according to the disinfection
procedures of the hospital. Recommended disinfectants include:
To Next Page
Loading...