P1 Patient Monitor User’s Manual
3-7
3.4.2. Adjusting the Screen Brightness
The steps to set the screen brightness are as follows:
1. Set the brightness in one of the following ways:
Select
【
Brightness
】
quick key.
Select
【
Screen Setup
】
quick keyselect
【
Other
】
submenu.
Select
【
Main screen
】
qick key
from【Disply】column to select【Other】
2. If the monitor operates on AC power，please set 【Brightness】；If the patient
monitor operates on battery power，please set【Brightness On Battery】.
3.
When the
【
Brightness
】
set as
【
Auto
】
,the screen will change to the
brightness automatically according to the environment light intensity.
NOTE
：
When the patient monitor enters standby mode, the screen brightness will be
automatically adjusted to the lowest.
When the AC power is interrupted and the battery is powered, the screen
brightness is automatically set to the corresponding brightness when the
battery is powered. You can still manually adjust the brightness as needed.
3.4.3. Setting the Date and Time
1. Enter the 【System Time】 page in one of the following ways:
Select【Main Menu】from【System】column to select【Time】, enter
the 【System Time】.
Click the system time in the system status information area on the
monitor to enter the 【System Time】 page.
2. Select【Date】and【Time】to
set the current date and time.
3. Select【Date Format】.
4. If you need to use 12 hours format, turn off 【24-Hour】.
If the monitor is connected to the central monitoring system, the system time of the
To Next Page
Loading...