info@biopac.com
support@biopac.com
www.biopac.com
BIOPAC Hardware | BSLCBL SERIES | Page 1 - 2 Updated: 3.29.2013
BSLCBL CABLE SERIES
BSLCBL1A: Stimulator to Nerve Chamber – Banana Plug
BSLCBL2A: Stimulator to Nerve Chamber – 2 mm Pin Plugs
BSLCBL3A: Nerve Chamber to BSL – Banana Plugs
BSLCBL4B: Nerve Chamber to BSL – 2 mm Pin Plugs
BSLCBL5: 3.5 mm Phone Plug
BSLCBL6: Stimulator to Output – 3.5 mm Mono Phone Jack
BSLCBL7: Stimulator to Electrode – BNC to 2x Alligator
BSLCBL11: Stimulator to Electrode – BNC to 2x Electronic Test Clip (spring-loaded)
BSLCBL12: Stimulator to Electrode – BNC to 2x Toothless Alligator
BSLCBL8/9: High Impedance – 1.5 mm Touchproof
BSLCBL14: MP36/35 Input Adapter for Research Amplifiers
INTERFACE CABLES
Stimulator to Nerv
e Chamber
Interface the BSL Stimulator with nerve conduction
chambers. A BNC connector interfaces with the
stimulator and two plugs attach to the nerve chamber.
Gold-plated
Stackable ground
1.2 me
ter.
BSLCBL1A
Banana Plugs
BSLCBL2A
2mm Pin Plugs
Nerve Chamber to Biopac Student Lab
Interface nerve conduction chambers with the Biopac
Student Lab System; use to record the signals coming
from the nerve.
A BSL DSub 9 connector interfaces
with the Biopac Student Lab MP3X unit and two
plugs attach to the nerve chamber.
1.2 meter
BSLCBL3A
Banana Plugs
BSLCBL4B
2mm Pin Plugs
BSLCBL3A/4B SPECS
Gain: 1/10 (divide by 10)
Input Impedance (Common-Mode): 5e11 Ohms (500 GigaOhm)
Common-Mode Rejection: 90 dB Typical
Input Bias Current: 3pA Typical, 100 pA
Maximum Voltage Noise: 1.3 µV p-p
Voltage Noise Density: nV /SQRT(Hz)
Current Noise Density: 0.01 pA /SQRT(Hz)
To Next Page
Loading...