info@biopac.com
support@biopac.com
www.biopac.com
BIOPAC Hardware | NIBP100D | Page 3 - 3 Updated: 2.12.2013
Hyperbaric/Hypobaric Chamber Setup
1. Cuff controller and CNAP monitor must be in the same chamber with the same"pressure" environment as
both are equipped with pressure sensor for surrounding pressure.
2. Pressure must be increased / decreased continuously rather than abruptly.
3. Hypobaric: take measures against overheating of the device as conventional cooling is limited (dim
CNAP display low; do not restrict airflow through case).
4. No draught on cuff.
5. Hand on heart level in steady position.
To Next Page
Loading...