info@biopac.com
support@biopac.com
www.biopac.com
BIOPAC Hardware | OUT SERIES | Page 2 - 4 Updated: 1.6.2014
See also: SS9LA BNC Input Adapter
OUT2 BNC (M) OUTPUT ADAPTER
This BNC adapter is designed to output signals from t
he MP3X unit to
other devices (such as external amplified speakers and scopes). This 2-
meter adapter cable terminates in a male BNC for easy connections.
OUT2 SPECIFICATIONS
Cable Length: 2 meters
Connector Type: BNC (male)
OUT100
These monaural headphones can be used with the STM100C stimulator
module to deliver a tone signal while recording data for startle response
or other stimulus-response studies. The headphones can also be used to
listen to raw signals (such as EMG), piped through the STM100C from
an amplifier output. The OUT100 is a wide response, high efficiency
headphone, weighing 85 grams and is equipped with a 1.8 meter cord
terminated in a 6.3 mm (1/4") phone plug.
OUT100 SPECIFICATIONS
Weight: 85 grams
Connector Type: 6.3 mm (1/4")
Cable length: 1.8 meter
Speaker: 28 mm dia 32 ohm dynamic Mylaar
Impedance: 16 Ohm @ 1.0 kHz
Power Handling: 100 mW max
Frequency response: 20 Hz - 20 kHz
Average SPL: 108 dB ± 4 dB
Adapter (included): 1/4" mono adapter plug
OUT101 TUBEPHONE
OUT101 Components: one Tubephone, plastic tube and 50 foam ear inserts
Use the OUT101 tubephone to deliver clicks and tones in auditory evoked response applications (i.e. ABR).
The tubephone design consists of a monaural acoustic transducer attached to a short, flexible, plastic tube, which
fits into the subject’s ear with the aid of a foam tip.
Use of the tubephone reduces ambient noise and bone conduction problems, which can interfere with auditory
response recordings. Furthermore, because the Tubephone provides a 1 msec acoustic signal delay (due to plastic
tube), it automatically separates true response from electromagnetic artifact resulting from speaker activation.
OUT101E Replacement Foam Ear Inserts: pkg. of 50
OUT101T Replacement Plastic Tubes: pkg. of 4
To Next Page
Loading...