EasyManua.ls Logo

BIOPAC Systems MP36 - Page 19

BIOPAC Systems MP36
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
info@biopac.com
support@biopac.com
www.biopac.com
BIOPAC Hardware | STIMULATORS MP3X | Page 7 - 9 Updated: 2.27.2013
BSLSTM SPECIFICATIONS (This older unit uses dial reading and a flip range switch)
Pulse width
Controlled by: Computer, with lockable width limit
Range: .2 – 100 milliseconds
Resolution: 2 microseconds
Accuracy: 5% (Can be improved to better than 2% using the “Correction factor” in the
“Stimulator Preferences’ window.)
Correction factor Range: 0 - 150 microseconds
Average value: 110 microseconds
Pulse Repetition
Controlled by: Computer
Pattern: Selectable (1-254 pulses) or continuous
Range—No Load: 5 seconds - .3 milliseconds Period (.2 - 3,333 Hz Rate)
Range—Load: 2 K Ohm load
0 - 10 Volt Range: 5 seconds to the following minimum repetition period:
100 ms P.W. 150 ms
10 ms P.W. 10.1 ms
1 ms P.W. 1.1 ms
0 - 100 Volt Range: 5 seconds to the following minimum repetition period:
100 ms P.W. 100 Volts: beyond functional limits
50 Volts: 250 ms
10 ms P.W. 100 Volts: 200 ms
50 Volts: 150 ms
1 ms P.W. 100 Volts: 20 ms
50 Volts: 2.5 ms
Limits: User adjustable lower and upper rate limits
Resolution: 2 microseconds
Accuracy: Better than 2%
Initial Pulse Delay
Time range: None or .5 - 100 milliseconds
Resolution: 2 microseconds
Pulse level
Controlled by: Manually (10 turn potentiometer)
Range (switchable): Range 1: .025 - 10 Volts
Range 2: .15 - 100 Volts
Infinite (potentiometer adjustable) range
Accuracy: 5% accuracy to dial indicator
Reference Output
Correlates to actual pulse output (Requires Calibration)
Pulse width: 15 millisecond fixed pulse width
Amplitude: 0 - 10 mV correlates to 0 – 10V actual output or 0 – 100V actual output
Manual Test Pulse
(Button on back panel)
Note: Will only function when “Trigger” cable is not
connected to the MP3X.
Pulse Width: 2.5 - 3 milliseconds
Stimulator isolation
Volts: 2,000 Volts DC (HI POT test)
Capacitance
coupling:
60pF
Power requirements
12 Volts DC adapter (included), 1 Amp
Fuse
250V, 2A, fast blow
Dimensions:
1.25” length .25” diameter
Module Weight
610 grams
Module Dimensions
16 cm x 16 cm x 5 cm
HARDWARE GUIDE

Table of Contents