Trigger 50
Use a Custom Video Trigger
Custom video triggering supports frame rate of 25Hz, 30Hz, 50Hz and 60Hz, and the line range is available from 300 to
2000. The steps below show how to set custom trigger.
1. Press the Setup key to enter the Trigger menu.
2. Press the Type softkey, then use the Universal Knob to select Video.
3. Press the Source softkey, then use the Universal Knob to select CH 1 as the trigger source.
4. Press the Standard softkey, then use the Universal Knob to select Custom as the trigger source.
5. Press the Setting softkey to enter the custom setting function menu.
6. Press the Interlace softkey, then use the Universal Knob to set the desired value.
7. Press the Of Field softkey, then use the Universal Knob to set the desired value.
8. Press the Sync softkey to enter the TRIG ON menu.
9. Press the Type softkey to select Any or Select.
• If Select was chosen:
– Press the Line softkey, then use the Universal Knob to set the desired value.
– Press the Field softkey, then use the Universal Knob to set the desired value.
To Next Page
Loading...
