Using ATEM Software Control
When applying ‘paste to all’, a warning message will appear
askingyou to confirm your action. This is so you don’t accidentally
paste new settings to any unlocked cameras that are currently on air.
Iris/Pedestal Control
The iris/pedestal control is located within the cross hairs of each camera controller.
The control illuminates red when its camera is on air.
To open or close the iris, drag the control up or down. Holding the shift key allows only
iris adjustments.
To darken or lift the pedestal, drag the control left or right. Holding the command key
on a Mac, or the Control key on Windows, allows only pedestal adjustments.
The iris/pedestal control illuminates red when its respective camera is on air.
Zoom Control
When using compatible lenses with an electronic zoom feature, you can zoom your lens
in and out using the Zoom control. The controller works just like the zoom rocker on a
lens, with telephoto on one end, and wide angle on the other. Click on the zoom control,
located above the Coarse slider, and drag up to zoom in, or drag down to zoom out.
66
To Next Page
Loading...
