19
Routine Service
Lifting the Outboard
2
Engine Care Products
The engine care products listed in the table below are referenced in this service manual, and are recom-
mended for use with Evinrude E-TEC outboards.
Lifting the Outboard
Use correct Lifting Fixture to lift outboard:
With recoil starter removed, Place lifting tool on
flywheel and seat the three screws completely.
Refer to Recoil Starter Removal on p. 317.
Fasten appropriate chain hook to eye of tool.
Carefully hoist outboard with chain and unbolt out-
board mounting brackets from frame.
Engine Care Product Notes
A HPF Pro Gearcase Lubricant Containers available in various sizes, see PAC Catalog
B Biodegradable TNT Fluid, P/N 763439 Use only in Power Trim & Tilt System of 3-cylinder models
B Power Trim/Tilt Fluid, P/N 775612 Use only in Power Tilt System of 2-cylinder models
C Triple-Guard Grease, P/N 508298
D Starter Bendix Lube, P/N 337016 IMPORTANT: Use no other products
E Hydraulic Fluid, P/N 770891
Anti-Corrosion Spray
“6 in 1” Multi-Purpose Lubricant
WARNING
To avoid personal injury, make sure the lifting
capacity of the hoist is at least twice the
weight of the outboard.
DO NOT allow the lift hook or chain from the
hoist to come in contact with any part of the
engine during lifting.
NOTICE
Use only the 1 1/8 in. (short) screws,
P/N 398067, included with the tool to avoid
damage to electronic components under the
flywheel.
Model Lifting Fixture
40–90 HP
P/N 396748 with
1 1/8 in. screws
1. Lifting fixture
2. 1 1/8 in. screws
002098
To Next Page
Loading...
