253
Midsection
Exhaust Housing, 3-Cylinder Models
11
Exhaust Housing,
3-Cylinder Models
Exhaust Housing Removal
Before removing the exhaust housing:
• Remove the gearcase. Refer to Gearcase
Removal and Installation on p. 46.
• Remove the powerhead. Refer to Powerhead
Removal on p. 197.
Remove and discard four lower mount screws.
Remove the exhaust housing.
Lower Mount Service
Remove lower mount covers and inspect the
lower mounts.
If replacement is necessary, lubricate mount with
soapy water and carefully pry at both ends to
remove.
If removed, coat the lower mounts with soapy
water and press into the exhaust housing with the
“OUTSIDE” mark facing outward.
“20” Models
23036
“25” Models
32590
001986
001971
001970
To Next Page
Loading...
