29
Routine Service
Adjustments
2
Clamp Removal
Method 1: Position Oetiker pincers across clamp
ear and cut clamp.
Method 2: Lift end of stepless clamp with screw-
driver.
Method 3: Use Oetiker pincers (pliers) to grip
clamp. Pull clamp off of connection and discard.
Adjustments
Steering Friction Adjustment
Tiller models are equipped with a steering friction
adjustment. Steering friction is not required when
remote steering is used.
Adjust steering friction with outboard mounted to
boat by loosening or tightening the adjustment
screw. Steering friction should be adjusted so a
slight drag is felt when turning.
000108
000090
000091
WARNING
Do not over-tighten. The steering friction
screw is not intended to allow “hands off”
steering.
1. Steering friction adjustment—Manual tilt models
001256
1. Steering friction adjustment—Power tilt models
005116
To Next Page
Loading...
