199
Powerhead
Powerhead Removal
10
3-Cylinder Models
Remove lower motor covers. Refer to Lower
Cover Removal on p. 56.
Disconnect power trim connectors.
Remove pin and washer from shift rod lever to
release the lower shift rod.
Remove six retaining screws and exhaust relief
muffler.
Install Lifting Fixture, P/N 396748, on flywheel and
seat the three screws completely.
Fasten appropriate chain hook to eye of tool and
support weight of powerhead with hoist.
WARNING
Protect against hazardous fuel spray. Before
starting any fuel system service, carefully
relieve fuel system pressure. Refer to Reliev-
ing Fuel System Pressure on p. 168.
Disconnect the Crankshaft Position Sensor
(CPS) to prevent accidental starting while
servicing.
002152
1. Shift rod pin
002013
002159
NOTICE
Be sure to use only the 1 1/8 in. (short)
screws, P/N 398067, included with the tool to
avoid damage to electronic components
under the flywheel.
1. Lifting fixture
2. 1 1/8 in. screws
002098
To Next Page
Loading...
