BRP E-TEC EVINRUDE - Latch Handle Installation

57
Engine Cover Service
Lower Cover Service
3
• Place port side cover into position on outboard.
Start the screw above the exhaust relief grommet
first. Tighten just enough to hold the grommet in
place.
Start the top front screw next and draw cover
halves together.
Install remaining cover screws and tighten all
screws to 24 to 36 in. lbs. (3 to 4 N·m).
Latch Handle Installation
Apply a light coat of Triple-Guard grease to latch
handle shaft. Insert handle into lower cover.
Apply Ultra-Lock to screw threads. Place spring
washer and hook into position and tighten screw
1. Trim cable grommet
2. Trim/tilt switch connector
002216
1. Start this screw first
2. Exhaust relief grommet
002157
1. Start this screw second 002165
1
2
1
2
1
1. Lower cover screws 002168
1. Triple-Guard grease 006470
1
1
1
1
1
1
1
1
1