81
System Analysis
Diagnostic Procedures
5
• Check the Engine Temperature Profile for evi-
dence of cold running or overheating.
• The Last Two Minutes profile reports engine
run-time values during the last two minutes of
operation above 1500 rpm. Information is col-
lected once per second. The newest record is
first on the list. As each new record is added,
the oldest record is removed.
The Engine Identity Report provides a snap-shot
of current engine and sensor conditions. From the
Identity screen, press the Print button. Next, press
Printer to print, or PDF File to save the report.
Operational Inspections
Run the outboard to confirm actual symptoms
before performing any unnecessary procedures.
Inspection should include the following:
• Make sure the outboard can be cranked easily,
with no mechanical binding.
Check the EMM LED Indicators for system status
information. Refer to EMM LED Indicators on
p. 84.
Troubleshooting
Outboard will not crank, starter does not
operate:
•
Check condition of battery and cables (main
battery switch and cables). Make sure battery
cables are not reversed.
• Confirm that switched B+ is present at “A” termi-
nal (yellow/red wire) of starter solenoid with key
switch in the START position.
• Check ground at “B” terminal harness connec-
tion.
• Refer to Electric Start Tests on p. 108. Repair
starter or start circuit as needed.
Outboard cranks, will not start:
•
Check emergency stop switch and lanyard
• Check powerhead mounted neutral switch
• Check the EMM LED Indicators for system sta-
tus information. Refer to EMM LED Indicators
on p. 84.
Engine Temperature Profile
008588
Last Two Minutes Profile
008589
Engine Identity Report
008590
To Next Page
Loading...
