223
Powerhead
Upper Mount Servicing (3-cylinder)
10
Dislodge mount assemblies and remove.
Inspect mounts and replace if necessary.
IMPORTANT: The motor mount, washer, and
screw are serviced as an assembly. Do not disas-
semble.
Installation
Place mount assemblies in position, with flats fac-
ing away from each other.
Apply Moly Lube to all sides of retainer and install
between mounts.
Install the retainer screw and tighten to a torque of
15 to 20 ft. lbs. (20 to 27 N·m).
002132
39820
002133
002134
To Next Page
Loading...
