257
Midsection
Exhaust Housing, 3-Cylinder Models
11
and three upper screws and tighten to a torque of
60 to 84 in. lbs. (7 to 9.5 N·m).
Apply Adhesive 847 to the bottom flange of the
inner exhaust housing. Install a new seal. Apply
Triple-Guard grease to outer seal surface.
Clean and degrease the adapter housing and
outer exhaust housing mating surfaces with
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
Place the adapter/inner exhaust housing into the
exhaust housing. Guide the water tube through
the hole in the outer housing and the alignment
pin into the adapter housing.
Apply Gasket Sealing Compound to threads of the
four retaining screws and tighten to a torque of 60
to 84 in. lbs. (7 to 9.5 N·m).
1. Lower inner exhaust housing screws
001974
1. Upper inner exhaust housing screws
001975
1. Seal
2. Bottom flange
001973
001983
1. Alignment pin
001980
1. Adapter retaining screws
001981
To Next Page
Loading...
