Buell 2002 P3 - Page 169

3-22 2002 Buell P3: Engine
HOME
27. See Figure 3-41. Install front isolator mounting bolt,
spacer snubber and new nut.
28. Tighten front isolator mounting bolt to 63-70 ft-lbs (86-95
Nm).
29. See Figure 3-42. Install crankcase breather hose and
crankcase breather into rocker box grommet.
30. Install horn. See 7.22 HORN.
31. Remove jack from under the motor.
32. Install muffler. See 2.20 EXHAUST SYSTEM.
33. Install fuel tank. See 4.2 FUEL TANK COVER/FUEL
TANK.
34. Install new oil filter, engine oil and primary chaincase
fluid as necessary.
35. See Figure 3-33. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
11WARNING1WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
36. Connect both battery cables, positive cable first. See
7.16 BATTERY.
37. Install seat. See 2.28 SEAT.
Figure 3-41. Front Isolator Mount
Figure 3-42. Install Crankcase Breather Hose
1. Frame
2. Locknut
3. Snubber
4. Bolt
5. Spacer
6. Front Isolator
7. Standoff
1
a0162x6x
23
4
5
6
7
7629