2002 Buell P3: Drive/Transmission 6-1
HOME
SPECIFICATIONS 6.1
NOTE
Service wear limits are given as a guideline for measuring
components that are not new. For measurement specifica-
tions not given under SERVICE WEAR LIMITS, see NEW
COMPONENTS.
ITEM
NEW COMPONENTS Service Wear Limits
Primary Drive (Engine-to-Transmission)
Engine sprocket – number of teeth 35 N/A
Clutch sprocket – number of teeth 56 N/A
Ratio* 1.60:1 N/A
Final Drive (Transmission-to-Rear Wheel)
Transmission sprocket – number of teeth 27 N/A
Rear wheel sprocket – number of teeth 80 Replace at 15,000 mi
Secondary drive belt – number of teeth 139 Replace at 15,000 mi
Ratio 2.96:1 N/A
Transmission
Primary drive / transmission lubricant capacity 32 fl. oz. (946 ml) N/A
Overall gear ratios**
First gear (low) 12.74 N/A
Second gear 8.77 N/A
Third gear 6.79 N/A
Fourth gear 5.60 N/A
Fifth gear (high) 4.74 N/A
* Internal gear ratios indicate number of mainshaft revolutions required to drive output sprocket one revolution.
** Overall gear ratios indicate number of engine revolutions required to drive rear wheel one revolution.
WET ClUTCH Multiple disc
CLUTCH PLATE THICKNESS
Friction plate (fiber) (in.) 0.0866 + 0.0031 N/A
Friction plate (fiber) (mm) 2.200 + 0.079 N/A
Steel plate (in.) 0.0629 + 0.0020 N/A
Steel plate (mm) 1.598 + 0.051 N/A
Clutch pack (in.) N/A .413 in. (minimum)
Clutch pack (mm) N/A (16.787)
MAXIMUM ALLOWABLE WARPAGE
Friction plate (fiber) (in.) N/A 0.0059
Friction plate (fiber) (mm) N/A 0.150
Steel plate (in.) N/A 0.0059
Steel plate (mm) N/A 0.150
To Next Page
Loading...
