Buell 2002 P3 - Page 344

2002 Buell P3: Electrical 7-17
HOME
DRIVABILITY TROUBLESHOOTING
Idle Speed Incorrect
Figure 7-16. Driveability Troubleshooting
Install 6-place Harness adaptor (HD-42962) and Breakout Box
using black connectors between connectors [88A] and [88B].
YES
Replace auto enrichener.
YES
NO
Disconnect connector [88] to
[10].
Is Battery voltage present
Replace Ignition
YES NO
Locate and
repair short
Replace fuse.
YES NO
Place red meter lead in Pin 2 and Black meter lead in Pin 1.
Start engine.
Is battery voltage present?
NO
With key ON, move black
meter lead to ground.
Is battery voltage present?
carburetor. Check continuity
from pin 1 on connector [88]
to pin 3 on connector [10B].
Is continuity present?
at both terminals of system
fuse?
Locate and repair open
on Orange wire between
system fuse and
connector [88].
Neither
Ter minal
Locate and repair
open on
1
Use black male probe
1
adaptor kit (HD-41404)
and patch cord from harness
YES
NO
Violet/Orange
wire.
Locate and repair
short to voltage.
Module
YES
NO
Locate and repair
open between
system relay and
system fuse.
Check for continuity
to ground at pin 2
on connector [88].
Continuity Present?
1 Terminal
1
to ground on
Orange wire.
Replace fuse.
NOTE
Male connectors are labeled “A”
Female connectors are labeled “B”
Reconnect connector
[88]?
(V/O) at connector
present on pin 1
Is battery voltage
7490
7495
7495
7495
7505
7516
7510
7517