2002 Buell P3: Electrical 7-49
HOME
ADJUSTMENT
Tilt headlamp up or down to aim it in relation to the horizontal
line. At the same time, turn headlamp right or left to direct
light beam straight ahead.
1. Adjusting head lamps.
a. Aim headlamp.
b. Tighten both adjuster screws (metric) to 6-8 ft-lbs (8-
11 Nm).
NOTE:
Use a standard phillips screwdriver on the right side
headlamp mounting stud to change lateral alignment.
Turn the stud clockwise to shift beam to the right; turn
the stud counterclockwise to shift beam to the left.
c. See Figure 7-67. Tu rn vertical headlamp mounting
adjuster clockwise to raise beam height.
d. See Figure 7-67. Tu rn horizontal headlamp mount-
ing adjuster clockwise to change lateral alignment.
Figure 7-67. Headlamp Vertical/Horizontal Adjusters
a0253x7x
Vertical Headlamp
Adjuster
Horizontal Headlamp
Adjuster
To Next Page
Loading...
