2002 Buell P3: Maintenance 1-5
HOME
Table 1-1. REGULAR MAINTENANCE INTERVALS
ODOMETER READING
SERVICE OPERATIONS
(see chart code below)
1
0
0
0
mi
2
5
0
0
mi
5
0
0
0
mi
7
5
0
0
mi
1
0
0
0
0
mi
1
2
5
0
0
mi
1
5
0
0
0
mi
1
7
5
0
0
mi
2
0
0
0
0
mi
2
2
5
0
0
mi
2
5
0
0
0
mi
Change engine oil and filter (includes draining crankcase breather hose)
RIRIRIRIRIR
Inspect air cleaner and filter element, service as required
II
Change rear belt and rear sprocket
R
Check clutch adjustment
IIIIII
Change transmission/primary chain case lubricant and clean drain plug—See
dealer
RRRRRR
Check/adjust primary chain
AAAAAAAAAAA
Inspect brake pad linings and discs for wear (front and rear)
IIIIIIIIIII
Change rear brake pads and rear brake pins
R
Check brake fluid reservoir levels and condition
IIIIII
Check rear brake pedal operation
IIIIII
Inspect oil lines and brake system for leaks
IIIIIIIIIII
Lubricate front brake hand lever, throttle control cables, clutch control cables (and
hand lever) and side stand
LLLLL
Lubricate and adjust steering head bearings X
Check operation and throttle control IIIIIIIIIII
Inspect fuel valve, lines and fittings for leaks IIIIIIIIIII
Clean fuel tank filter screen X
Check operation of all electrical equipment & switches including starter interlock IIIIIIIIIII
Check battery and clean connections IIIIIIIIIII
Change spark plug RR
Check tire pressure and inspect tread IIIIIIIIIII
Check wheel bearings*
Change front fork oil X
Check stabilizer links and engine mounts II
Check tightness of all critical fasteners: hand controls, brake system, axle nuts,
front fork components, riser and handle bar fasteners.
TT
Check rear shock absorber II
Check ignition timing II
Check engine idle speed IIIIIIIIIII
Inspect exhaust system hardware; including muffler strap II
Road test XXXXXXXXXXX
* Whenever wheel is removed (tire change, fork fluid change, etc.)
NOTE:
See Table 1-1. The following codes are for the REGULAR MAINTENANCE INTERVALS Table:
I - Inspect & if necessary correct, clean or replace.
A - Adjust.
R - Replace or change.
T - Tighten to proper torque
L - Lubricated with specified lubricant
X - Perform
To Next Page
Loading...
