1-18 2002 Buell P3: Maintenance
HOME
11WARNING1WARNING
To avoid accidental start-up of vehicle and possible per-
sonal injury, disconnect the battery cables before pro-
ceeding. Inadequate safety precautions could result in
death or serious injury.
5. Disconnect negative battery cable from battery.
6. Remove left footpeg support bracket. See 2.21 FOOT-
PEGS AND FOOTPEG SUPPORT BRACKETS.
7. Remove three TORX screws with washers (1) from
clutch inspection cover (2). Remove clutch inspection
cover from primary cover.
CAUTION
Do not overfill the primary chaincase with lubricant.
Overfilling may cause rough clutch engagement, incom-
plete disengagement, clutch drag and/or difficulty in
finding neutral at engine idle.
8. See Figure 1-15. Add SPORT-TRANS FLUID (Part No.
98854-96 quart size; Part No. 98855-96 gallon size) as
required until fluid level is even with bottom of clutch dia-
phragm spring.
9. See Figure 1-14. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 7-9 ft-lbs (9.5-12.2 Nm).
10. Install footpeg support bracket. See 2.21 FOOTPEGS
AND FOOTPEG SUPPORT BRACKETS.
11. Connect negative battery cable to battery. Tighten fas-
tener to 60-96 in-lbs (6.8-10.9 Nm).
12. Install seat. See 2.28 SEAT.
11WARNING1WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation, causing loss of control of vehi-
cle and death or serious injury.
To Next Page
Loading...
