256
256
256cab Produkttechnik GmbH & Co KG
O - Set Print Options
N = Negative (inverted) printout of the complete label
R=Rotate the label contents 180 degrees
P = Printmode - backfeed option always / smart
backfeed „always“ feeds the label back and starts printing at the
label margin, while „smart“ suppresses the feedback.
„P“ activates the smart option while
„D“ activates the „always“ option.
This option overwrites temporarily the settings in the printer´s
setup.
Using the „smart“ mode has the benefit that the printer processes
thelabels faster as the time is saved for pulling the labels back.
Nevertheless a negative effect may appear in the area where the
label is stopped under the printhead. This may cause a small
horizontal white line in the area. If this happens within an object,
then you must select the „D“ option to avoid this effect.
S = Single label buffer. The following label will be processed when the
actual one has finished printing.
T = Enables the „Tear off mode“ which feeds the label more forward
after printing, so that it could be taken easier away.
U = Unique label - suppresses the Pause / Reprint possibility to avoid
that a label will be printed twice.
Important: The "O" command must be located directly after the label size command "S....."
To Next Page
Loading...
Need help?
General
