93
93
93cab Produkttechnik GmbH & Co KG
A - Amount of Labels
The A command is used to define the end of the label definition and to set the amount of labels to be
printed. The printer repeats internally the defined label where the amount is defined by this command.
The label will stay in the printer´s internal buffer, after it has been sent to the printer.
sending the A command multiple times afterwards will print the amount of labels which is specified by
the A command.
A [n]
CR
A - amount of labels
n = number of labels to print (Multiple options are available:)
[NOPRINT] = receives and processes the label, but suppresses
a printout. (Used for saving a label on
memorycard). It is also possible to key in [NO]
instead of [NOPRINT]
[?] = printer prompts on its display for the quantity or is
also used to be replaced from any attached system
[REPEAT] = Repeats the label at the end (makes only sense
together with the [?]option.
It is also possible to use [R] instead of [REPEAT]
[$DBF] = Prints each record of a database. Number of
records = number of labels.
A -without any value prints until the print job is cancelled
J
S l1;0,0,68,71,100
T 25,10,0,5,8;LABEL PRINTER
A 550
prints 550 labels with the text line: „LABEL PRINTER“
J
S l1;0,0,68,71,100
T 25,10,0,5,8;LABEL PRINTER
A
prints "infinite" amount of labels
Example:
Example:
Syntax:
To Next Page
Loading...
Need help?
General
