390
390
390cab Produkttechnik GmbH & Co KG
[WTAG ... ] Write RFID TAG
Writes the RFID Tag in bytes
[WTAG:start{,len}]
[WTAG:...] - write tag ID
start = start address (Byte)
len = length (Byte)
Writes the RFID TAG whereby "start" and "len" are bytes. If the content is too short it will be filled up
with zero bytes. This command writes blockwise ! If len is missing the printer writes as much as data is
available. Start must be devideable through the block size. First address in a TAG is " 0 ".
Writes data in the codepage which had been previously defined with the "E command".
m m
J
S l1;0,0,68,70,100
T 20,20,0,5,5;CABRFID[SER:1][WTAG:0][I]
A1
The example writes new content into a tag
This function requires that the printer is equipped with the optional cab RFID reader
RFID Functions
Example:
Syntax:
To Next Page
Loading...
