CAB A+ Series - Escs Printer Status Query

51
51
51cab Produkttechnik GmbH & Co KG
ESCs Printer status query
ESCs Printer status query,which responds through the interface
ESCs
Answer: XYNNNNNNZ
where:
X = Online (Y=Yes, N=No)
Y = Type of error:
NNNNNN = amount of labels to print
Z = Interpreter active (Y=Yes = print job is in process,
N=No= printer in Standby mode)
Error types:
- ---------------------------------------------------------------------------------No error
a ---- Applicator error- ----- Applicator did not reach the upper position
(1)
b ---- Applicator error- ------ Applicator did not reach the lower position
(1)
c ---- Applicator error– ------------------------------ Vacuum plate is empty
(1)
d ---- Applicator error- ------------------------------------- Label not deposit
(1)
e ---- Applicator error- ----------------------------------------- Host stop/error
(1)
f ----- Applicator error- -------------------------- Reflective sensor blocked
(1)
g ---- Applicator error --------------------------------------- Tamp pad 90° error
h ---- Applicator error -----------------------------------------Tamp pad 0° error
i ----- Applicator error --------------------------------Table not in front position
j ----- Applicator error -------------------------------- Table not in rear position
k ---- Applicator error --------------------------------------------------- Head liftet
l ----- Applicator error --------------------------------------------------Head down
m ------------------------------------------------------------- Scanresult negative
(4)
n ------------------------------------------------------------- global Network error
(3)
(this can be: no link, no timeserver, no SQL client,
no SMTP server, no DHCP server or IP adress conflict)
o -------------------------------------------------------------- Compressed air-error
r---------------------------------------------------------------------------- RFID -error
s ------------------------------------ System fault (immediately after power on)
u ----------------------------------------------------------------------------- USB error
... continued on the next page...
Syntax: