214
214
214cab Produkttechnik GmbH & Co KG
C - Cutter Parameters
The C command is used to set the parameters for the optional cutter or perforation cutter. The cutting
command uses the label counter to cut after a specified amount of printed labels or can be set to cut at
the job end. Additonally it is possible to perform a second cut (double-cut) in one label.
Furthermore an optional perforation cutter is available, which can perforate and which is also able to
do a "regular" cut.
C x[,disp1[,disp2]]
CR
C - cutting command
x = cutting method - valid parameters are:
amount = amount of labels after which a cut is processed.
Possible values 1-9999
e = cutting at the job end.
Cuts once at the job end which is defined by the "A"
(amount) command.
s = cut at print start (before the first label. This command is
only executed once in the job and can be combined
with " C amount ". disp1 is an optional offset in the
chosen unit.
p = perforate - requires the optional perforation cutter !
sp = perforate at the start of the printjob ( requires the
optional perforation cutter !, and can be combined
with " C amount ". disp1 is an optional offset in the
chosen unit.
disp1 = (displacement 1) - offset to the end of the defined label
disp2 = (displacement 2) - offset to the first cutting position.
(always positive values !)This double cut option offers the possibility
to cut off portions of a label. [disp2] is not available when the „cut
before first label ( s) parameter is used. disp2 is only available for
regular cuts and not for perforations !
Please see also the "O" command to adjust the cutting time ( cutting depth ) for the perforation
cutter. All measurements in millimeters or in inches (see the „m“ command)
Optional cutter required
Syntax:
To Next Page
Loading...
