59
59
59cab Produkttechnik GmbH & Co KG
<ENCRYPTED LABEL...> - Start of an ENCRYPTED label
This command marks the start of an encrypted label file, followed by the board number.
Important: This command requires additional action from cab. It cannot be used without the help
through cab.
<ENCRYPTED LABEL; nnnnnnnnnnnn>
CR
nnnnnnnnnnnn = unique main board number
Each "X2" mainboard has a unique serial number which can be used beneath a lot of other features to
encrypt label contents to protect your programming work.
Label encryption needs to be done by cab or by registered cab resellers only !
A label which looks like this here:
J
S l1;0,0,68,71,104
T 10,10,0,3,5;Test label, encrypted
A 1
may look like the 2 lines below after it is encryped.
<ENCRYPTED LABEL: 111063523313>
r??@,?h??)(?H=J??2?*?r0?e???1??H??7?‘Q>
This file can then be loaded for example from on a memory card. It will only execute on this specific
printer with the serial number "111063523313"
Please contact the cab representative if you need more details.
The description of this command has been added for your understanding, just in case if you are
confronted with this command in the ASCII dump mode.
Syntax:
To Next Page
Loading...
Need help?
General
