383
383
383cab Produkttechnik GmbH & Co KG
Example:
[WTMP] Write value to serial (TMP) file
Writes a value to a previously defined temporary file on the printer´s memory card.
[WTMP]
[WTMP] - Write value to serial file
m m
J
S l1;0,0,68,71,100
E TMP;EXAMPLE
T:XVAL;10,10,0,3,3;[RTMP,1][I]
T:SERNO;10,10,0,3,3;[+:XVAL,1][D:0,0][I][WTMP]
T:TESTFELD;10,20,0,3,8;Serial number is: [SERNO]
A4
The value of the file EXAMPLE will be saved in the value XVAL.
The value increases in our example in steps of 1 whereby the result is saved on the memory card in
the file EXAMPLE.TMP.
EXAMPLE.TMP is located in the „MISC“ folder on the memory card. The value in the example.TMP file
is "4" after printing these 4 labels. (The printout shows only the last printed label)
Please note: The maximum length is 128 characters. This command cannot be used with the internal
Flash File system (IFFS). Never switch your printer off while data is written to the memory card.
Loss of information or damage of the memory card would be the result. This command can not be
used together with the internal flash file system (IFFS).
See also the command [RTMP] Read value from serial (TMP) file.
Special Functions
Syntax:
To Next Page
Loading...
Need help?
General
