53
53
53cab Produkttechnik GmbH & Co KG
ESCs Printer status query
Note: Immediately when a job has started the printer will send a Y and sets this value back to N when
the last label of this job is printed.
(1) This status request can only be processed on printing systems which are equipped with an
attached applicator !
(2) Error messages for optional devices such as „cutter jammed“ depend on the availability of the
optional device and may vary between different printer types. i.e. No cutter errors on Hermes A4
applicators (These options are not available for these models.)
(3) Network error: Only on printers with an optional or built in network interface. (No print server)
(4) Scanresult negative requires an optional barcode scanner. The availability of the optional barcode
scanner depends on the printing system.
(5) Status requests should not be sent in very short cycles ! Minimum time between a status request
should be not less than 0.5 seconds.
To Next Page
Loading...
Need help?
General
