9-9
Mixing & Effects
output port (note that not all MIDI devices support chorus and reverb
controller messages).
You can control the mixing and playback of a MIDI track as follows:
To do this... Do this...
Add a real-time MIDI effect
to the track
Right-click in the Effects patch point and select
an effect from the list (for more information, see
“Using Real-Time Effects” later in the chapter)
Remove an effect Select the effect and press
Delete
or right-click
and select
Delete
.
Select the output port Click the Port button and choose one from the list
Select the channel Click the Channel button and choose one from
the list
Select the bank Click the Bank button and choose one from the
list
Select the patch Click the Patch button and choose one from the
list
Set the Chorus level Adjust the Chorus slider
Set the Reverb level Adjust the Reverb slider
Mute the track Click the Mute button
Solo the track Click the Solo button
Arm the track for recording Click the Arm button
Set the Pan level Adjust the Pan fader
Set the Volume level Adjust the Volume fader
Select the input source Click the input source button and choose one
from the list
Tip:
You can control the level of all MIDI tracks at once by grouping the
MIDI faders. For more information, see ÒUsing Control GroupsÓ later
in this chapter.
To Next Page
Loading...