14-10
The options described below occur in the [Options] section of the
TTSSEQ.INI Þle. You can edit this Þle using the Windows Notepad. Every
time you add or change one or more lines in ttsseq.ini, you must restart
Pro Audio in order for the change to take effect.
SysxSendDelayMsecs=n
This setting causes Pro Audio to delay n milliseconds if it encounters an
F7 in a System Exclusive bank.
n = 60 Default value (in milliseconds)
SysxDelayAfterF7=n
This setting causes Pro Audio to delay Sysx transmission for a certain
amount of time if it encounters an F7 in a System Exclusive bank. This
gives some instruments the required amount of ÒbreathingÓ time
necessary to process the Sysx transmission. The default delay is 1/18 of a
second, but can be changed by also adding the SysxSendDelayMsecs=n
line.
The possible values of n are 0 and 1. Their signiÞcance is as follows:
n = 0 No delay
n = 1 Delay between each Sysx string
SysxSendPacketSize=n
System Exclusive bytes are transmitted in packets, with a 1/18-second
default delay between each packet. Setting this value to a smaller
number will help slower synthesizers avoid overßowing their internal
buffers. This line sets the number of bytes between each Sysx transmit
delay.
n = 1024 Default value (in bytes)
Troubleshooting
Pro Audio Is Not Receiving Sysx Messages
Make sure you have the right MIDI Input port selected by using the
Options-MIDI Devices command. Also, make sure that your
instrument is set up to transmit System Exclusive data.
Sysx Bank Names Don't Show When I Open a File
Sysx bank names are only saved in .wrk Þles (not in .mid Þles or .syx
Þles). If you use the Save Bank button in the Sysx View, the data are
saved as a standard MIDIEX format Þle. There are no provisions for
MIDIEX to remember the bank names.
To Next Page
Loading...