CAKEWALK PRO AUDIO - Pro Audio as the Master

15-6
Pro Audio as the Master
There are several options, found in the Project Options dialog box,
which you can use when Pro Audio is the MIDI Sync master device:
4. Make sure that your MIDI interface is highlighted in the Input
Ports list, and click OK.
5. Click on the Sync toolbar to use the MIDI Sync clock source.
From now on, Pro Audio starts playback and recording only after the
appropriate message is received from the master device.
Option… What it’s for…
Use Start, Never Continue If you are using an external drum machine
to repeat a drum pattern or loop, you
might always want playback on the drum
machine to start at the beginning of the
loop. When this option is chosen, Pro
Audio sends a Start message to all slave
devices when playback is started, even if
you are in the middle of a song.
(Normally, Pro Audio would send a
Continue message if playback starts from
the middle of a song.)
Transmit MIDI Song Position Pointer
(SPP)
When this options is checked, Pro Audio
sends an SPP message before starting or
continuing playback. If you are using a
drum machine as described previously,
you might want to disable this option.
Tip:
Make sure the status bar is displayed when using MIDI Sync.
Otherwise, you will not be able to see the MIDI Sync status messages.
To display the status bar, choose Options-Global and click the
General tab. Then check the Show Status Bar box.