11-7
StudioWare
The minimum and maximum values of the faders look like this:
To Create a Group of Controls...
1. Select any control by clicking on it with the mouse.
2. Hold down the Ctrl key and click on one or more additional
controls.
Pro Audio creates a group from the selected controls.
To Remove Controls from a Group...
1. Hold down the Ctrl key and click on any control in the group.
Pro Audio removes the control from the group.
To Adjust a Single Control in a Group...
1. Hold down the Shift key and drag the control to a new value.
The range for the control is adjusted so that its current position
corresponds with the current position of other controls in the group.
Example: To Set Two Faders for a Crossfade...
1. Move the two faders to their midpoint.
2. Click on the first fader, and then Ctrl-click on the second to
create a group.
3. Move both faders to their highest position.
4. Shift-drag the second fader to its lowest position.
5. Drag the first fader to its lowest position.
6. Shift-drag the second fader to its highest position.
These two controls are now grouped so that they move in opposite
directions.
Fader... Starting value... Ending value...
#1 0 127
#2 127 0
To Next Page
Loading...