E-6
SendLocalOff=<0 or 1> Boolean 1 (enable) This line determines whether or not Pro Audio
should send a Local Control OFF message
during startup.
SendLocalOn=<0 or 1> Boolean 0 (disable) This line determines whether or not Pro Audio
should send a Local Control ON message at
exit.
SyncAllowRateTweak=< 0 or
1>
Boolean 1 (enable) When synching to SMPTE, Pro Audio normally
attempts to track the rate of the incoming sync
signal, in order to survive dropouts better
when the SMPTE source speed is slightly off.
Setting this to 0 defeats this. If you have a
slower computer and dense work to play,
defeating this can result in a small efficiency
improvement and also prevent rate-tracking
timing inaccuracies when the computer is so
busy that it’s late processing incoming sync
messages.
SysxDelayAfterF7=<0 or 1> Boolean 1 (enable) This setting causes Pro Audio to delay Sysx
transmission for a certain amount of time if it
encounters an F7 in a Sysx bank. This gives
some instruments a required amount of delay
time that is necessary to process the Sysx
transmission. The default delay is 1/18 of a
second, but can be changed by also adding the
SysxSendDelayMsecs=<n> line (see below).
The possible values are 0 and 1. Their
significance is as follows:
0: no delay
1: delay between each Sysx string (F0 … F7)
SysxSendDelayMsecs=<num> Integer 60 This setting causes Pro Audio to delay a
specified number of milliseconds if it
encounters an F7 in a Sysx bank.
SysxSendPacketSize=<num> Integer 1024 This line specifies the number of bytes between
Sysx transmit delays. Sysx bytes are
transmitted in packets, with a 1/18 second
delay between each packet. Setting this value
smaller will help slower MIDI devices
(synthesizers, etc.) avoid overflowing their
internal buffers.
UseCableMetaEvents=<0 or
1>
Boolean 1 (enable) This line specifies whether or not Pro Audio
should use nonstandard “Cable” meta-events
for storing Sysx bank port number into
Standard MIDI files (by default, n=1).
To Next Page
Loading...