CAKEWALK PRO AUDIO - Page 579

I-11
Roland U-8
Play buttons—When a Play
button is highlighted (yellow),
it allows that input to be
heard.
Move the Cursor buttons until the blue frame
encloses the four Play buttons. Use Effects/
Mixer Control knobs 1-4 to choose values.
Solo buttons—When a Solo
button is highlighted (yellow),
it solos that input.
Move the Cursor buttons until the blue frame
encloses the four Solo buttons. Use Effects/
Mixer Control knobs 1-4 to choose values.
High EQ—Turn these knobs to
boost or cut the high band of
the EQ (this EQ is always pre-
fader).
Move the Cursor buttons until the blue frame
encloses the two High EQ buttons. Use Effects/
Mixer Control knobs 3-4 to choose values.
Low EQ—Turn these knobs to
boost or cut the low band of
the EQ (this EQ is always pre-
fader).
Move the Cursor buttons until the blue frame
encloses the two Low EQ buttons. Use Effects/
Mixer Control knobs 3-4 to choose values.
Pre/Post—Toggle this button
between Pre and Post to send
the input signal to the effects
processor either pre or post
fader.
Move the Cursor buttons until the blue frame
encloses the two Pre/Post buttons. Use Effects/
Mixer Control knobs 3-4 to choose values.
Send—Turn this knob to
control how much of the
input signal goes to the
effects processor.
Move the Cursor buttons until the blue frame
encloses the Send buttons. Use Effects/Mixer
Control knobs 3-4 to choose values.
Insert—Press this button to
add an Insert Effect to an
input. When this button is
highlighted in yellow and
reads “Insert,” the Insert
Effect is active. If you apply a
System Effect, the button
reads “System.”
Move the Cursor buttons until the blue frame
encloses the three Insert buttons. Use Effects/
Mixer Control knobs 2-4 to choose values.
Balance—These knobs control
the left/right balance (pan) of
an input.
Move the Cursor buttons until the blue frame
encloses the four Balance buttons. Use Effects/
Mixer Control buttons 1-4 to choose values.
White faders—Each of the
four white faders controls the
playback or record level of an
input.
Make sure U-8’s Track Group Indicator reads
Audio+MIDI, and move faders 5-8 on the U-8
module.
Mixer Button or Control... How to Control It…