M-Series Operator’s Manual 4/9/15
10-66
F2 - Tool Lib. Now you need to make sure that each tool uses the correct
diameter and height offset values. Inspect the values for T001.
T1 should use H001 and D001. If any of these values are
incorrect, use the arrow keys to select the incorrect values. Enter
the new values in their places and press ENTER to accept them.
You may also select spindle and coolant settings for your tools
here, or enter a short description of the tool.
F10 - Save Keep the updated Tool Library values.
ESC/CANCEL Leave Tool Setup. Return to the CNC software Setup Screen.
ESC/CANCEL Leave CNC software Setup. Return to the CNC software Main
Screen.
CYCLE START The CYCLE START button is located on your jog panel. This
key will cause the mill to begin cutting your part
Tutorial Complete!
To Next Page
Loading...
