M-Series Operator’s Manual 4/9/2015 10-15
Canned Cycle Introduction #2: Linear Repetition of Operations
(Drilling, Boring, Tapping)
If you want to perform one operation several times in a linear pattern, simply define Position X, Y or both as
incremental values. To do this, use the F1 – Abs/Inc Key. This key will toggle the Position value mode between
incremental and absolute. If you define X and/or Y as incremental values, a new field will appear asking for the
number of holes:
The numbers in the fields on the screen correspond to the following example, shown here graphically:
To Next Page
Loading...
