E-3
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
OL-20798-01
Appendix E Basic Phone Administration Steps
Configuring the Phone
Adding a User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications
Manager Administration by following these steps:
Procedure
Step 1 Choose User Management > End User, then click Add New. The End User Configuration
window appears.
Step 2 In the User Information pane of this window, enter the following:
• User ID—Enter the end user identification name. Cisco Unified Communications Manager does not
permit modifying the user ID after it is created. You may use the following special characters: =, +,
<, >, #, ;, \, , "", and blank spaces.
Example: johndoe
• Password and Confirm Password—Enter five or more alphanumeric or special characters for the end
user password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and blank
spaces.
• Last Name—Enter the end user last name. You may use the following special characters: =, +, <, >,
#, ;, \, , "", and blank spaces.
Example: doe
• Telephone Number—Enter the primary directory number for the end user. End users can have
multiple lines on their phones.
Example: 26640 (John Doe’s internal company telephone number)
Step 3 Click Save.
Step 4 Proceed to Configuring the Phone, page E-3.
Configuring the Phone
First, perform the following procedure to identify the user’s phone model and protocol:
Procedure To Select Phone Model and Protocol
Step 1 From Cisco Unified Communications Manager administration, choose Device > Phone >.
Step 2 Click Add New.
Step 3 Select the user’s phone model from the Phone Type drop-down list, then click Next.
Step 4 Select the device protocol (SCCP or SIP) from the drop-down list, then click Next. The Phone
Configuration window appears.
To Next Page
Loading...
