Cisco Catalyst 3750 - Page 47

1-9
Catalyst 3750 MetroSwitch Software Configuration Guide
78-15870-01
Chapter 1 Overview
Default Settings After Initial Switch Configuration
Passwords None defined Chapter 5, “Administering the Switch”
TACACS+ Disabled
RADIUS Disabled
System name and prompt Switch
NTP Enabled
DNS Enabled
802.1x Disabled Chapter 8, “Configuring 802.1x
Port-Based Authentication”
Port parameters
Operating mode Layer 2 (switchport) Chapter 9, “Configuring Interface
Characteristics”
Port enable state All ports are enabled.
Interface speed and duplex mode Autonegotiate
Auto MDIX Disabled
Flow control Off
VLANs
Default VLAN VLAN 1 Chapter 10, “Configuring VLANs”
VLAN trunking Dynamic auto (DTP)
Trunk encapsulation Negotiate
VTP mode Server Chapter 11, “Configuring VTP”
VTP version 1
Voice VLAN Disabled Chapter 12, “Configuring Voice VLAN”
Tunneling
802.1Q tunneling Disabled Chapter 13, “Configuring IEEE 802.1Q
and Layer 2 Protocol Tunneling”
VLAN mapping Disabled
Layer 2 protocol tunneling Disabled
Spanning Tree Protocol
STP PVST+ enabled on VLAN 1 Chapter 14, “Configuring STP”
MSTP Disabled Chapter 15, “Configuring MSTP”
Optional spanning-tree features Disabled Chapter 16, “Configuring Optional
Spanning-Tree Features”
IGMP snooping
IGMP snooping Enabled Chapter 17, “Configuring IGMP Snooping
and MVR”
IGMP filters None applied
MVR Disabled
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature Default Setting More information in...