Cisco Catalyst 3750 - Page 48

1-10
Catalyst 3750 Metro Switch Software Configuration Guide
78-15870-01
Chapter 1 Overview
Default Settings After Initial Switch Configuration
Port-based Traffic
Broadcast, multicast, and unicast storm
control
Disabled Chapter 18, “Configuring Port-Based
Traffic Control”
Protected ports None defined
Unicast and multicast traffic flooding Not blocked
Secure ports None configured
CDP Enabled Chapter 19, “Configuring CDP”
UDLD Disabled Chapter 20, “Configuring UDLD”
SPAN and RSPAN Disabled Chapter 21, “Configuring SPAN and
RSPAN”
RMON Disabled Chapter 22, “Configuring RMON”
Syslog messages Enabled; displayed on the console Chapter 23, “Configuring System Message
Logging”
SNMP Enabled; version 1 Chapter 24, “Configuring SNMP”
ACLs None configured Chapter 25, “Configuring Network
Security with ACLs”
QoS Disabled Chapter 26, “Configuring QoS”
EtherChannels None configured Chapter 27, “Configuring EtherChannels”
IP unicast routing
IP routing (and routing protocols) Disabled Chapter 28, “Configuring IP Unicast
Routing”
Multi-VRF-CE Disabled
MPLS services
Label switching Globally enabled; disabled per
interface
Chapter 30, “Configuring MPLS and
EoMPLS”
EoMPLS Not configured
MPLS QoS Disabled
HSRP groups None configured Chapter 29, “Configuring HSRP”
IP multicast routing Disabled on all interfaces Chapter 31, “Configuring IP Multicast
Routing”
MSDP Disabled Chapter 32, “Configuring MSDP”
Fallback bridging Not configured Chapter 33, “Configuring Fallback
Bridging”
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature Default Setting More information in...