Cisco Catalyst 3750 - Page 677

28-75
Catalyst 3750 MetroSwitch Software Configuration Guide
78-15870-01
Chapter 28 Configuring IP Unicast Routing
Configuring ISO CLNS Routing
Table 28-15 lists the privileged EXEC commands for clearing and displaying ISO CLNS and IS-IS
routing. For explanations of the display fields, refer to the Cisco IOS Apollo Domain, Banyan VINES,
DECnet, ISO CLNS and XNS Command Reference for Release 12.1, use the Cisco IOS command
reference master index, or search online.
Table 28-15 ISO CLNS and IS-IS Clear and Show Commands
Command Purpose
clear clns cache Clear and reinitialize the CLNS routing cache.
clear clns es-neighbors Remove end system (ES) neighbor information from the
adjacency database.
clear clns is-neighbors Remove intermediate system (IS) neighbor information from the
adjacency database.
clear clns neighbors Remove CLNS neighbor information from the adjacency
database.
clear clns route Remove dynamically derived CLNS routing information.
show clns Display information about the CLNS network.
show clns cache Display the entries in the CLNS routing cache.
show clns es-neighbors Display ES neighbor entries, including the associated areas.
show clns filter-expr Display filter expressions.
show clns filter-set Display filter sets.
show clns interface [interface-id] Display the CLNS-specific or ES-IS information about each
interface.
show clns neighbor Display information about IS-IS neighbors.
show clns protocol List the protocol-specific information for each IS-IS or ISO IGRP
routing process in this router.
show clns route Display all the destinations to which this router knows how to
route CLNS packets.
show clns traffic Display information about the CLNS packets this router has seen.
show ip route isis Display the current state of the ISIS IP routing table.
show isis database Display the IS-IS link-state database.
show isis routes Display the IS-IS Level 1 routing table.
show isis spf-log Display a history of the shortest path first (SPF) calculations for
IS-IS.
show isis topology Display a list of all connected routers in all areas.
show route-map Display all route maps configured or only the one specified.
trace clns destination Discover the paths taken to a specified destination by packets in
the network.
which-route {nsap-address | clns-name} Display the routing table in which the specified CLNS destination
is found.