Contents
xxvi
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Configuring Layer 3 EtherChannels 34-14
Creating Port-Channel Logical Interfaces 34-14
Configuring the Physical Interfaces 34-15
Configuring EtherChannel Load Balancing 34-17
Configuring the PAgP Learn Method and Priority 34-18
Configuring LACP Hot-Standby Ports 34-19
Configuring the LACP System Priority 34-20
Configuring the LACP Port Priority 34-21
Displaying EtherChannel, PAgP, and LACP Status 34-22
Understanding Link-State Tracking 34-22
Configuring Link-State Tracking 34-24
Default Link-State Tracking Configuration 34-24
Link-State Tracking Configuration Guidelines 34-24
Configuring Link-State Tracking 34-24
Displaying Link-State Tracking Status 34-25
CHAPTER
35 Configuring IP Unicast Routing 35-1
Understanding IP Routing 35-2
Types of Routing 35-2
Steps for Configuring Routing 35-3
Configuring IP Addressing 35-3
Default Addressing Configuration 35-4
Assigning IP Addresses to Network Interfaces 35-5
Use of Subnet Zero 35-5
Classless Routing 35-6
Configuring Address Resolution Methods 35-7
Define a Static ARP Cache 35-8
Set ARP Encapsulation 35-9
Enable Proxy ARP 35-9
Routing Assistance When IP Routing is Disabled 35-10
Proxy ARP 35-10
Default Gateway 35-10
ICMP Router Discovery Protocol (IRDP) 35-10
Configuring Broadcast Packet Handling 35-12
Enabling Directed Broadcast-to-Physical Broadcast Translation 35-12
Forwarding UDP Broadcast Packets and Protocols 35-13
Establishing an IP Broadcast Address 35-14
Flooding IP Broadcasts 35-15
Monitoring and Maintaining IP Addressing 35-16
To Next Page
Loading...
