EasyManuals Logo
Home>Cisco>Firewall>RV120W

Cisco RV120W Administration Guide

Cisco RV120W
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
Configuring Virtual Private Networks (VPNs) and Security
Configuring Advanced VPN Parameters
Cisco RV120W Administration Guide 97
5
NOTE Ensure that the authentication algorithm is configured identically on both
sides.
STEP 3 Choose the authentication method:
Select Pre-Shared Key for a simple password based key that is shared with
the IKE peer.
Select RSA-Signature to disable the pre-shared key text field and use the
Active Self Certificate uploaded in the Certificates page. A certificate must
be configured in order for RSA-Signature to work.
NOTE The double quote character (“) is not supported in the pre-shared key.
STEP 4 Choose the Diffie-Hellman (DH) Group algorithm, which is used when exchanging
keys. The DH Group sets the strength of the algorithm in bits.
NOTE Ensure that the DH Group is configured identically on both sides of the IKE
policy.
STEP 5 In the SA Lifetime field, enter the interval, in seconds, after which the Security
Association becomes invalid.
STEP 6 To enable dead peer detection, check the Enable box. Dead Peer Detection is
used to detect whether the peer is alive or not. If peer is detected as dead, the
router deletes the IPsec and IKE Security Association.
STEP 7 In the Detection Period field, enter the interval, in seconds, between consecutive
DPD R-U-THERE messages. DPD R-U-THERE messages are sent only when the
IPsec traffic is idle.
STEP 8 In the Reconnect after Failure Count field, enter the maximum number of DPD
failures allowed before tearing down the connection.

Table of Contents

Other manuals for Cisco RV120W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV120W and is the answer not in the manual?

Cisco RV120W Specifications

General IconGeneral
Ethernet LANYes
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
VPN tunnels quantity10
Ethernet LAN data rates10, 100 Mbit/s
Ethernet LAN interface typeFast Ethernet
Channels quantity13 channels
WLAN data transfer rate (max)300 Mbit/s
Input current1 A
Input voltage12 V
xDSL connectionNo
Dimensions (WxDxH)150 x 150 x 34 mm
Networking featuresFast Ethernet, WLAN, WAN
Operating temperature (T-T)32 - 104 °F
Security algorithms802.1x RADIUS, EAP, WPA2
Antennas quantity2
Antenna gain level (max)1.8 dBi
Ethernet LAN (RJ-45) ports4
CertificationFCC B, CE, IC, Wi-Fi
Product colorBlack
Storage temperature (T-T)-20 - 70 °C
Storage relative humidity (H-H)5 - 90 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Weight500 g

Related product manuals