Commend Duetto - Page 153

Control Station Duetto Appendix – Examples
2.0/0518 153
Registration failed: Registration and verification of the operational readiness has been failed.
The device is checking operational readiness of the device again later.
Connecting: The device is verifying operational readiness is trying to register on the server at the
moment.
Only in the web interface:
 Deactivated: Registration on this server and verification of operational readiness has been deacti-
vated by the user.
• Sequential mode
The DUETTO device registers on the main server, if possible. As long as the device can register on the
main server, operational readiness of the fallback server will not be verified. If registration on the main
server fails, the device registers on the fallback server 1. If this registration is successful, the device
stays registered on fallback server 1, as long as this fallback server is operational. If fallback server 1
also malfunctions, the device will register on fallback server 2. Only if fallback server 2 also malfunc
-
tions, the device again registers on the main server. With this mode, it is recommended to keep active
in the network only the currently operational server with the highest priority and to activate the fallback
server only if required.
Server states in sequential mode
In the web interface of the DUETTO device, several server states are shown on page SIP, field: SIP
servers:
Registered: Registration on the SIP server was has been successful. The SIP server is ready for
use. It is used for incoming and outgoing calls.
Inactive: Operational readiness of this server is not being checked at the moment.
Connecting: The device is registering on the server.
Only in the web interface:
Deactivated: Registration on this server has been deactivated by the user.
NOTE: Display of servers
Deactivated servers by the user, are not shown in the function menu device information of the web
interface.
NOTE: Status request
In sequential mode, no status request for servers that are not being used is carried out; in sequential
mode, the DUETTO device does not recognise if fallback servers are active.
NOTE: Display of servers
Deactivated servers by the user, are not shown in the function menu device information of the web
interface.